Low Deflection mounts
Navy shockproof and vibration mount. resist to 30G choc at low frequency.
The main role of these mounts is to isolate vibration. A snubber system limits the movement of the suspended mass (10 mm), however the loads developed in this case, are high. A wide load range from 0,5 to 32 daN depending upon the application. In case of shock protection, the structural resistance of the mount can accept acceleration of up to 150 g. These mounts are mainly suited for vibration, hence the loads generated in case of shock are very high. Fixation on the inside or on the outside.
► Intrinsically stable under impact, that is to say that they allow the mass to return to its initial position; the system does not retain any plastic deformation or residual buckling when the stresses of the impact have disappeared.
► The suspended mass can therefore undergo several successive shocks without risk. However, the stability of the assembly must be checked. beforehand in relation to the relative positions of the supports and the centre of gravity of the suspended mass
► The PAULSTRA marine supports also offer excellent vibratory and acoustic performance.
Marine support shall perform the following functions:
► Maintenance of the suspended mass in the absence of shock with a vibratory and/or acoustic insulation capacity;
► In case of shocks: limitation of force and/or displacement to acceptable values;
► After shocks: return of the suspended mass to its initial position.